I just took bed off and unbolted from engine then put the duals on but unless their is someway to quiet them down besides using hmf's little quiet core insert I'm takin them off and puttin stock back on
]]>Havent ran the snorkel hose yet but may just end up moving the entire air box to the front like you are talking about badley
I also plan to build a bolt on/off snorkel for the muffler
My question now is...With the snorkeled air box and snorkeled stock muffler...do yall think I could stick with the larger jet or should i just go back to stock? I am alot lower elevation then you badley and most on the site but lookin for advice from anyone
]]>I plan to snorkel the air box to the front like a lot of folks do
Only other question I had was if I were to go back with the stock exhaust along with the snorkeled air box would I need to go to smaller jet or could I leave the larger jet that I have in it now
Thanks
Pete
Pete, this link has some great info on tuning the Rhino carb. This site is due to go down, so if you find something useful - print it. Specifically look at "Rhino Jetting Procedure" and "Mikuni Performance Tuning". Hope this helps...
Brad
]]>Put in a 180 main jet which was recomended by HMF
My main question is...do I need to adjust the Fuel/Air Mix screw which is on the bottom of the carb or just the Idle Mix screw?
If I need to adjust the air/fuel on the bottom of the carb which way do i need to turn it...out/down or in/up?
On my honda foreman I installed a larger main jet (not sure the number) again recomended by HMF and only had to adjust the idle screw and have never had any problems and that was over a year or so ago
Anybody on here today that can offer some quic help?
Thanks alot
Pete
]]>